RESOLTECH 8010 W
Hardener 8015 W
Water based sprayable epoxy filler
- Models/patterns making
- Direct moulds
- Room temperature curing
- 1.7mm thick max by layer
- Very easy to sand
- No COV and CMR component
- Polystyrene compatible
RESOLTECH 8010 W / 8015 W system results of the latest advances in epoxy chemistry formulation and eliminates all solvents used normally with sprayable primers and fillers, replacing them with water, thus improving the H&S conditions for workers.
8010 W enables to produce models or direct moulds on any type of support previously milled by CNC or by hand.
This filler can be applied on all supports, composite, wood, foam, calibrated wax, polystyrene. It is recommended to apply a layer of 1010 ECO / 1014 on porous substrate as wood, this limit water absorption of this and avoid crack of 8010 W / 8015 W.
The 8010 W maybe sprayed with gravity spray guns with (3,5 mm nozzle) and pressure return on the roller, applied by brush or with a flat spatula. The fast drying characteristics and ease of sanding make it possible to apply various layers per day. Dilution ratio can be adapted to uses, 5% of water on mix for brush or roller apply, 20% of water on mix for spray gun apply.
It is best to apply the water based epoxy paint 4030W BLANC / 4034W as topcoat to close the surface and enable to laminate on the 8010 W. For a mat finish, use 4036 WM. This paint can be applied by brush, roller or spray gun. This result in hard finish with excellent chemical resistance.
.
- DS - 8010 W - 8015 W.pdfFilesize: 231.5 kB