Applications of HTG 160 for Applications of HTG 160 for

RESOLTECH HTG 160

Hardener HTG 165

High TG Structural Infusion Epoxy Systems

  •  TG >140 °C
  • Low viscosity and excellent wetting properties
  • High thermomechanical performances

RESOLTECH HTG-160 / HTG-165 resin is very high TG resin system specially formulated for the manufacture of tooling and large structural composites parts requiring TG’s and service temperature up to 140 °C.

Due to its low viscosity, high wetting properties and excellent air release, it is suitable for the manufacture of structures and composite parts by infusion, injection moulding. HTG-160 / HTG-165 system contains no CMR components or VOC to reduce user exposure.

The stable low viscosity vs temperature makes of the HTG-160 a prime choice for infusion process. However, this system is not recommended for wet lay up or filament winding because the hardener  HTG-165 is sensitive to moisture. For these applications, HTGL-160 / HTGL-166 is recommended.

This system gives high inter-laminar properties thanks to its exceptional wetting properties even on aramid reinforcements.

Laminates can be released from the moulds after a low temperature cure cycle (8h @ 40 °C) enabling to use of low TG plug material. Final thermo-mechanical properties will be obtained after a post curing cycle defined according later in this technical data sheet.

TG (°C)
140
Mix density
1.07
Mix viscosity (mPa.s)
266
Gel time on 70 mL, 4cm at 23°C
3h15m